Support Board
Date/Time: Sun, 22 Dec 2024 20:52:18 +0000
Post From: Custom Text Drawing# commands
| [2015-06-11 03:21:28] |
| Panicked Sheep - Posts: 3 |
|
Could you please add a keyboard shortcut command for the "Custom Text Drawing" tool that would allow one to switch to Previous/Next "Text Drawing#"? The tool concept itself is very handy, especially for Elliott Wave labeling, but its usefulness is severely hampered by the strict linearity and inflexibility resulting from the lack of such a command. Right now, I can't efficiently "skip through" Text Drawing# until I get the label I want, but I have to place every single label up to the desired one, deleting each as I do (which can take some time as I have 90 labels configured). Nor am I able to go back one or more steps in case an error was made, or if I just wish to place a text label from a previous config#. Instead I'm forced to start all over again to get to that point. The addition of this small but vital function would transform the tool for the better and make it a lot more practical to use, so I hope you guys can consider it. Thanks. |