Support Board
Date/Time: Wed, 05 Feb 2025 10:58:07 +0000
Post From: Removing being able to copy tool configuration name to tool on creation.
| [2025-01-06 21:05:30] |
| Sierra_Chart Engineering - Posts: 18279 |
|
Also, what is 'Mark 0' and 'Mark 1' for ? These draw small rectangles at the beginning and end of a drawing.We have done a thorough review of the issue, and some changes have been made. Although we were not able to reproduce the problem. There was an issue with Ray drawings with the copying of the configuration name/label to the drawing text. This will be resolved. We will have a new release out today. Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing Date Time Of Last Edit: 2025-01-06 21:06:10
|