Support Board
Date/Time: Sat, 23 Nov 2024 20:24:20 +0000
Post From: Denali Feed with IB
| [2024-08-02 12:02:40] |
| WarEagle - Posts: 73 |
|
Hi, I have the same issue, Denali for data, IB for trading. Are you saying in order to not have it try to load crappy IB data every time I start Sierra that I have to run a second instance with Denali? That means switching to another instance to trade from a chart which is very inefficient. Is there no way to have Denali data on my charts by default but trade from the chart through IB at the same time without a very complex reset every time I open Sierra? I use a lot of older intraday data from Denali for my analysis and each time I restart Sierra all charts get replaced with IB history which is terrible to non-existent. I have to change the Data/Trade service to SC Data-All Services, then reload all the charts by changing something in the chart settings to make it recalculate, then switch back to IB but tell it No when asked to translate the symbols. Then I have to manually change my trading chart to an IB symbol in order to trade. Is there an easier way to do this? |