Support Board
Date/Time: Tue, 26 Nov 2024 01:46:45 +0000
Post From: diff single line
| [2024-01-19 16:06:07] |
| John - SC Support - Posts: 36286 |
|
After we had given you the above information, we realized that what you are wanting to do is the same as multiplying by -1. Therefore, after you have your initial difference setup, you can use the following study to reverse the order: Multiply Charts - Bar If you have both of these in the same region, then they will show as just two lines at the top and bottom of the region, due to the difference in the values. You would need to change one of the Difference (Bar) studies to be a scaling of either "Independent" or "Same as Region". For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |