Support Board
Date/Time: Wed, 27 Nov 2024 20:29:01 +0000
Post From: Tools: Cycles, Gann Fan & Line Functionalities
| [2023-07-10 15:45:11] |
| John - SC Support - Posts: 36344 |
|
1. This is an OpenGL issue. We will have to look into it. If you want to see the Cycles then you will have to turn off OpenGL. 2. We are not able to reproduce this. What we are seeing is that the Gann Fan is using the "Chart Setting" for the "Value Increment per Bar" for each individual chart. Check what you have this set to in the chart where the lines are not showing. 3. We can not reproduce this. If you can give us very specific instructions on how you are able to make this occur, then we can see if we can find out what is occurring. 4. You can not adjust the Line Tool and keep the length constant. We are not sure what you mean by "Snap to the OHLC" (which is available) without changing the points? If you snap a line to the OHLC, then the points that define the line must change to match the location where the line is now drawn. -- We are too busy to take on any custom development at this time. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |