Support Board
Date/Time: Sat, 30 Nov 2024 06:38:23 +0000
Post From: Run code when DLLs are released?
| [2022-12-17 23:43:54] |
| ycomp - Posts: 321 |
|
are you 100% sure about that? because I had a breakpoint set and it only activated when I closed the chartbook, not when I had the chartbook still open and I disabled dlls.. I tested both of those ways on "fresh" instances but also what version do you use? I'm only on 2400. now my code is a bit involved so there is a chance that I'm wrong about this. I'll have to test it further tomorrow. But that is good to hear that it should work. I was going to make a workaround like have a heartbeat that if it wasn't received would exit the thread. |