Support Board
Date/Time: Wed, 05 Mar 2025 01:34:01 +0000
Post From: Lockup while in Configure Control Bar 1 >> Set Custom Tool
| [2022-01-04 21:51:45] |
| User180397 - Posts: 16 |
|
I have successfully configured a number of buttons in Customize Control Bar 1. Recently, attempting to add and configure another button, I was able to add a Custom Drawing Tool and then set its "Properties" without difficulty. I am also able to use the "Move Up" and "Move Down" buttons, and the "Add Separator" and "Add Blank" buttons. I can also "Remove" Control Bar commands. There are about 3 inches of blank space to the right of the last button on the Control Bar, suggesting I might be able to add at least another button in Control Bar 1. However, as I click on "Set Custom Tool" the entire SC program locks up. If I attempt to click on anything on the main screen I get an audible soft chime or "bling" sound - as if I need to first select something to proceed, but there are no options offered, and that was not the functionality I remembered during prior configurations. At that point, my only option is to close the program through Task Master. After restarting SC, I then selected an existing functioning button and clicked on the "Set Custom Tool" button and the program immediately locked up again. I've repeated this sequence a number of times. I recently changed some of the existing button tool configurations, under Global Settings>>Tool Config. That shouldn't disallow opening "Set Custom Tools" but..........? Any suggestions or thoughts? |