Support Board
Date/Time: Thu, 06 Mar 2025 03:56:18 +0000
Post From: Back again to Sierrachart
| [2022-01-04 17:14:41] |
| John - SC Support - Posts: 38425 |
|
Okay, thanks for the info! What do I have to change at AMP if I order the Sierrachart Trade Routing?
The Teton Order Routing Service is not supported by AMP. It is up to them when they decide if they will support it. If you are wanting to use the Teton Order Routing Service, then you would need to change brokers. You will find the list of supported brokers at Step #2 at the following link: Sierra Chart Teton Futures Order Routing: Setup Instructions Another small problem with my spread experiment: The chart only shows leg 1.
P/L also only shows the changes in leg 1 and not the spread itself. What do I have to do to see the spread itself? First, you should check and see if there is an exchange-traded spread already in existence for what you want to do. If so, then you can just trade that spread and not have to deal with setting everything up within Sierra Chart. Refer to the following: Real-Time Exchange Data Feeds Available From Sierra Chart: Exchange Traded Spreads Otherwise, you would need to use the Spread Order Entry Study, which it looks like you found. But refer to the instructions for this at the following link and make sure everything is setup properly: Spread Order Entry Study For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |