Support Board
Date/Time: Tue, 26 Nov 2024 08:30:08 +0000
Post From: Study Subgraph Diff as a CandleStick Bar
| [2021-03-24 18:37:29] |
| John - SC Support - Posts: 36286 |
|
What you are seeing is explained in the documentation for the Difference (Bar) study. Specifically, the following: The High and Low can change within a bar. The High will not always get higher and the Low will not always get lower. They are based upon the High and Low values between the two charts used in the calculation, respectively.
If the Open or the Close differences exceed the High or Low differences, then the High and/or Low are adjusted so that the Open or Close differences do not exceed them. For the greatest accuracy you may be interested in the High Accuracy Spread study configuration. So what you are seeing is that the High is constantly changing based on the actual values and may go lower. It could even go to a point where it is lower than the Open/Close and therefore is replaced with that value. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |