Support Board
Date/Time: Fri, 07 Feb 2025 01:05:12 +0000
Post From: Only one chart open, Over symbol limit message appears
| [2020-05-12 17:16:15] |
| LP30 - Posts: 9 |
|
So, when I open Sierra Chart I see on the top left "ST:0", meaning that there are zero symbols being tracked. Then, I proceed to open a watchlist with 100 symbols and cycle through the chart for each symbol one-by-one. Each time I update the symbol in the chart, the "ST" increments by one, so ST:1, ST:2, ST:3, etc. The "ST" symbol tracker never decreases. Once I exceed "ST:20", I start getting the "Over Symbol Limit" message and the "ST" counter only keeps increasing even after I have exceeded my 20 symbol limit. Is this the intended behavior? It seems to me like Sierra Chart should start unsubscribing from the old symbols in order to avoid exceeding the symbol limit. Simply disconnecting and reconnecting to the data feed will reset the "ST" number back to zero. However, having to do this after every 20 charts seems pretty cumbersome from a user-experience/UX perspective. |