Support Board
Date/Time: Mon, 03 Feb 2025 23:03:35 +0000
Post From: Rithmic DOM pulling-stacking restart
| [2018-11-18 15:37:55] |
| User912279 - Posts: 102 |
|
Dear Sierra, Sierra is a magnificent tool. Thank you for that! The base of my question is: I have Rithmic as a data provider, so I see a very deep DOM. Pulling/Stacking counting, as per Sierra's default setting, reset themselves only when the spread gets to them. However, sometimes a Stacking amount gets pulled after a longer period of having been Stacked and therefore this the net effect is zero, so it does not show as a Pulling (for example at 10.00 AM a level get stacked with 700 contracts, but then after 11.00 AM 700 get pulled: the Pulling/Stacking at this level will show basically no change, ie around zero). The question: To avoid the "misunderstanding" described above: It would be useful to have a time setting, where one could limit how long a Pulling or Stacking amount is "remembered". It is in my view a really important piece of Information and a vital Setting that would enable users to chose how long a Pulling/Stacking is remembered and included into the calculation of the net number. This could be time-related, or could be defined in renko bar or range chart bars, but in any case in my view the Pulling/Stacking information becomes quickly obsolete and should not be "remembered" too long. This is a really important piece of Information and a vital Setting that would enable much more visibility. It could be time-related, or could be defined in renko bar or range chart bars, but in any case: the pulling/stacking information becomes quickly obsolete and should not be "remembered". I have been contacted by others both in the Forum and personally, who see my point and joined in asking the question, so the request appears to be a valid concern. I would very much appreciate to hear back from you. |