Support Board
Date/Time: Sun, 19 Jan 2025 17:50:31 +0000
Post From: Current Version 1727
| [2018-04-16 19:19:39] |
| John - SC Support - Posts: 37327 |
|
Sorry, after reviewing what was done, we found that the tool is working correctly in this recent version. There was a bug previously where the Fibonacci Fan was incorrectly showing the Extend option. It did allow for the fan to start out not being extended, but it would not cycle correctly from that point forward. Therefore it was changed to not display until there was a proper extension point available. In this current version, in order to allow extensions to take place, you must first Cut the drawing. After which, you can cycle the Extend option on/off. The previous post has been removed to avoid confusion. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |