Support Board
Date/Time: Fri, 22 Nov 2024 21:25:47 +0000
Tool Config - Show End Point Price
View Count: 94
| [2024-09-25 12:58:30] |
| Benutzer4711 - Posts: 35 |
|
Hello When setting up Tool Configs the Setting for Show End Point Price stay at "No" all the time. When using the Tool the Price is actually shown, but its not clear when this setting is set to Yes based on A) Apply All or B) Save Config That's affecting Horizontal Lines + Horizontal Rays. Please check on this. Thanks Date Time Of Last Edit: 2024-09-25 14:08:55
|
 Tool Config Window.jpg / V - Attached On 2024-09-25 12:56:00 UTC - Size: 336 KB - 29 views |
| [2024-09-25 14:58:07] |
| John - SC Support - Posts: 36237 |
|
We do see that the setting for "Show End Point Price" in the Tool Configuration is not properly showing as "Yes" when it has been set to this value. We will take care of this.
For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |
To post a message in this thread, you need to log in with your Sierra Chart account: