Support Board
Date/Time: Mon, 25 Nov 2024 08:30:41 +0000
Volume Profile Start time?
View Count: 301
| [2024-03-14 21:16:25] |
| anthonyvegas - Posts: 13 |
|
I would like to create a volume profile that begins at the open of the RTH session 9:30 EST and builds out the profile over a specific amount of volume, 250,000 lots for example. Then, begins building the next volume profile, for another 250,000 lots. I have tried countless settings and cannot seem to get this working. I can setup a volume based "Multiple profiles based on bar count" and then apply it to a chart setup with Volume per bar. But I cannot get the start time to work in any way. Your help with this is greatly appreciated.
|
| [2024-03-15 13:21:48] |
| John - SC Support - Posts: 36238 |
|
There is not an option to have both a Start Time and a profile based on volume. The best option is what you have done with the Volume per Bar. To get a start time, just be sure your session start time is 09:30 EST and that you have the option for "New Bar at Session Start" set to "Yes". Refer to the following: Chart Session Times Another option would be to have a chart that starts at 09:30 EST and has only 1 day loaded. Then add the Volume by Price setup for the Volume you want. The only downside to this is that once the volume is accumulated, it will not start a new profile, it will just continue to roll forward with the 250,000 volume by dropping the earliest bar's volume from the calculation. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |
To post a message in this thread, you need to log in with your Sierra Chart account: