Support Board
Date/Time: Thu, 28 Nov 2024 21:35:36 +0000
Intraday Download interval
View Count: 287
| [2023-03-27 01:26:22] |
| dubbs - Posts: 36 |
|
At the web page at the link below which discusses the Sierra Chart Teton Futures Order Routing, in the section under "Setup Instructions", in the image which shows the Data/Trade Service Settings, there is a line which says Intraday Download Interval for Non Realtime Symbols. What is a typical setting for that and what does that setting affect? Should that setting be a smaller number if we are trading very small time frames, or not necessarily? That setting is set to 30 in the image at the following link. Is that a normal setting that works well for most people? thanks Sierra Chart Teton Futures Order Routing: Setup Instructions |
| [2023-03-27 08:08:28] |
| Sierra_Chart Engineering - Posts: 17206 |
|
That setting does not apply if the symbol will receive streaming real-time or delayed data. Otherwise, it controls the time that historical data is downloaded for these other symbols. And you can normally set that 10 or 20 minutes. It is up to you. For most people it really would not be relevant since it is not applicable to symbols you would be using.
Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |
| [2023-03-27 12:21:57] |
| dubbs - Posts: 36 |
|
thank you
|
To post a message in this thread, you need to log in with your Sierra Chart account: