Support Board
Date/Time: Fri, 17 Jan 2025 05:50:13 +0000
Trade Order Matching Error
View Count: 1461
| [2017-12-06 10:14:28] |
| aydex - Posts: 110 |
|
Hi, Followed the instructions here Attached Orders: Order Quantity Matching but once the order is to be filled (no fill occurs,) the green match notification goes red, and seeing this error Trade Order Error: The order quantity for the Parent is 1 and this is less than the total order quantity of 2 for the Attached Orders. Adjust the order quantities so the parent is greater or equal to the Attached Orders. I am using the supplied "2TargetsWithCommon Stop" twconfig, with no mods except to change Main window qty to 2. I have set Allow Multiple Entries in Same Direction to Yes in the spreadsheet study. Are there any other limiters to the qty? |
| [2017-12-06 10:23:30] |
| |
|
This just means you cannot use 2 Target orders if the parent order quantity is 1. Remove one of the Target orders. This is very simple. This is not hard to understand.
Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service: Sierra Chart Teton Futures Order Routing Date Time Of Last Edit: 2017-12-06 10:23:49
|
| [2017-12-06 10:38:22] |
| aydex - Posts: 110 |
|
Sorry I wasn't clear, to restate: Changed Main window qty to 2, to match the two targets. Assumed that increasing the Main window qty is an alternative to decreasing one of the Target orders? Wanting 2 target orders, just like this example Attached Orders: Multiple-Bracket Example (and in "2TargetsWithCommon Stop") Would understand if during the setup its was red, but it doesn't go red until the fill is expected. |
| [2017-12-06 18:50:40] |
| |
|
You need to set the quantity of 2 on the Spreadsheet Sheet itself: http://www.sierrachart.com/index.php?page=doc/SpreadsheetSystemsAlertsAndAutomatedTrading.php#CellJ26 It sounds like it is set to 1 and when the order is submitted from the Spreadsheet, is when the Trade Window updates. Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service: Sierra Chart Teton Futures Order Routing |
To post a message in this thread, you need to log in with your Sierra Chart account: