Support Board
Date/Time: Wed, 15 Jan 2025 15:56:40 +0000
Snap to High/Low on TPO Profile Charts
View Count: 1272
| [2017-08-09 13:28:34] |
| User796776 - Posts: 95 |
|
When using the Snap to High/Low on a TPO Profile Chart the result is (on a 1 tick tpo chart) a tick above or below the actual High/Low being selected. Using the same feature on a bar/candle chart works as expected with the actual high/low being chosen. Should the Snap to High/Low feature be consistent on a TPO chart or is there a reason for this difference? |
| [2017-08-09 13:36:45] |
| |
|
You cannot use any of the drawing tool Snap commands on a TPO Profile Chart. It is not going to work properly.
Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service: Sierra Chart Teton Futures Order Routing |
To post a message in this thread, you need to log in with your Sierra Chart account: