Support Board
Date/Time: Fri, 24 Oct 2025 07:48:35 +0000
OEC symbols
View Count: 1021
| [2015-07-29 13:22:39] |
| User244592 - Posts: 48 |
|
I am using OEC and when loading symbols I occasionally get a symbol error message , though the data loads properly. At times these symbols that gave this message stop updating. If I disconnect, then reconnect it updates fine. At some later time it may need to be reconnected again. I am running S5 trader at the same time but not using the same symbol in both programs.
|
| [2015-07-29 17:04:44] |
| |
|
Refer to this section here: https://www.sierrachart.com/index.php?page=doc/openecry.php#SymbolLimit You have gone over the OEC symbol limit. Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service: Sierra Chart Teton Futures Order Routing |
To post a message in this thread, you need to log in with your Sierra Chart account: