Support Board
Date/Time: Sat, 23 Nov 2024 00:15:50 +0000
manually move multiple stop orders on chart
View Count: 2349
| [2013-06-10 12:32:04] |
| cross - Posts: 70 |
|
Hi, Is it possible to move multiple stop lines on a chart which are in different OCO of the same trade and apparently fit to the same level.. so I wanna move all-in-one ? By pressing shift/control for the mouse drag? Thanks |
| [2013-06-10 17:35:10] |
| |
|
This depends. Are these Stop Attached Orders and was the Stop set to the All OCO Groups OCO Group?
Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service: Sierra Chart Teton Futures Order Routing |
| [2013-06-10 18:00:48] |
| cross - Posts: 70 |
|
I have 3 targets (scaling out). There are Attached Stops assigned to their target counterparts (OCO Group 1..3, moving to BE and trailing for the 3rd position). As I see I can use - one stop for all targets (All OCO Groups) OR - same number of stops as targets (OCO Group 1..x) but cannot mix both. After some move the remaining stops stay at the same level and I expect to move them manually all-in-one (occasionally) but suddenly realize that I move only one of the stops at a time. I understand that this is not an error but I'm looking for some ease of clicks :) Thanks! |
To post a message in this thread, you need to log in with your Sierra Chart account: