Support Board
Date/Time: Sat, 21 Dec 2024 18:09:19 +0000
drawing support
View Count: 924
| [2015-03-03 11:12:34] |
| navigator - Posts: 27 |
|
When I draw parallel lines I have all the options checked, enable vertical lines, mark anchors, extend forward, allow horizontal shift. This will show me the dots that I have to connect with a ray or line to draw the midline of the parallel lines. Unfortunately when I switch tools from parallel rays to a line or ray to draw the midline, the dots will disappear. I need those dots to remain while I switch tools. How is that done? Or is there another way of drawing the midline between parallel lines. Thanks
|
| [2015-03-03 17:44:22] |
| |
|
If you want a midline between the parallel lines, you need to add a 50% Level to the Parallel Lines configuration: https://www.sierrachart.com/index.php?page=doc/doc_Tools.html#DrawingToolConfiguration Refer specifically to the Parallel Lines subsection in this section. Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service: Sierra Chart Teton Futures Order Routing Date Time Of Last Edit: 2015-03-03 17:44:41
|
To post a message in this thread, you need to log in with your Sierra Chart account: