Support Board
Date/Time: Thu, 16 Jan 2025 09:08:07 +0000
Post From: V1382 Exits when $J$8=0 even though formula AND Condition is $J$8>0
| [2016-03-17 18:58:44] |
| User791263 - Posts: 151 |
|
You NORMALLY do not get involved in users' auto-trading systems & permutations that could occur. Since you worked on simulation fills in V1382, consider this a possible exception to your rule. There seems to be one other bug than only the one I first posted. Since V1382, I've been testing mostly the same forumlas as just before (which were working,all trades showing up on spreadsheet), which progress I record meticulously for an audit history. I see what appears a bug in Buy fills sometimes not showing on the spreadsheet, yet ARE on the Trade Activity>Trades Log. The Buy entries occurs as the Formula says to do,but nothing appears for some trades, on the Spreadsheet (about 10% of trades). No I don't allow an exit in a Buy entry bar. Exits seem to work for most trades, mostly (except for my original post issue above). But exits do not seem to recognize these Buys that do not get into the K-Column but only in the Log and on the Chart. All Buy fills show up on the Chart and Trades log. It seems that the program sometimes fails to post a Buy Entry into the spreadsheet, but doing everything else. Auto settings are as in the first post. Yes, it is the correct sheet, as most trades do show up as occur. No, I have no other trading spreadsheet active to stop or belay a buy signal. It is very simple, with one chart, one sheet active, one other sheet with nothing in K,L,M,N. This should be easy for you to test,using any scalping system with 10-second to 1-minute bars that enter often--- to confirm the problem, since only about 10% of orders that appear on the log don't appear on the spreadsheet. Nor does the spreadsheet "Detail" formula-debug show logic or trues "to buy" for the entry that shows up on the Trades Log. Could the speed of 60X be an issue where there are 40 charts, 7 spreadsheets, many studies? Tests are set on ALL Charts, Skip Empty periods, Accurate Trading Back test mode. This problem is during Replay mode, 1-Sec processing. Storage is set 1-Sec. |