Support Board

Date/Time: Sun, 22 Dec 2024 12:15:48 +0000

Post From: GANN FAN TOOL

[2015-04-14 03:45:09] Link To Thread - Link To Post [Go To First Post]
Al SC Developer - Posts: 434
In the next version, the Gann fan and grid have new modes that allow the main Gann line to be set with the second mouse click. This new behavior is the default, but the old behavior is also maintained. Within the tool config, you can not specify how the Value Increment Per Bar is specified (used to be called Value Per Point). The options are to set the value from the second click, use the value from the config, or use the chart value. If you need to use both new and old behavior, then you can configure multiple tool configs and switch between them. The Gann Fan and Fib Fan can also now be cut at a specific bar (all lines are cut at same point).