Support Board
Date/Time: Mon, 23 Dec 2024 02:05:26 +0000
Post From: Drawing Tools: a few requests
| [2015-01-09 21:03:00] |
| WarEagle - Posts: 73 |
|
Hi, I love the drawing tools SC supports and use them a lot. There are a couple of enhancements that would make my drawing analysis faster and cut down on some of the manual adjustments as well as adding new functionality. 1) Rectangle scale: I would like to be able to lock the length and width ratio of the anchors of the rectangle tool so that the same shape can be re-sized without changing the ratio. For example, I would like to be able to draw a square (length/width ratio of 1) and then re-size it where it stays a square as the size changes. This would be great for the ellipse tool as well so that I could enlarge a circle without having to constantly adjust the second anchor to try and keep it a circle. 2) Rectangle base angle: I would like to be able to rotate the square (rectangle) to align with trend lines or other non-horizontal angles. 3) Gann Fan base angle: I would like to be able to draw the Gann Fan base to align with a trend line so that the fan lines start from the trend line angle rather than the horizontal as it does now (see attached pic for a hand drawn example). Thanks in advance! |
 gann_fan_from_trendline.jpg / V - Attached On 2015-01-09 20:51:30 UTC - Size: 16.79 KB - 380 views |