Support Board
Date/Time: Sun, 22 Dec 2024 11:20:19 +0000
Post From: Problem with
| [2014-12-10 05:20:34] |
| pointfisher - Posts: 3 |
|
When drawing a ray on a log scale chart, the ray, as rendered, does not pass through the second anchor point. The degree of deviation seems to depend on the angle of the ray (it's most noticeable when the ray has about a 45 degree slope). A workaround is to use the parallel rays tool, turning off all but the primary line. The parallel rays tool does not exhibit this behavior (although it the tool itself does have a slight anomaly when used on a log scale chart). Observed in versions 1183 through 1217. http://www.sierrachart.com/image.php?l=1418188527778.png |