Support Board
Date/Time: Sat, 23 Nov 2024 02:53:18 +0000
Post From: Preventing a custom study from recalculating and sending an order when reopening a symbol
| [2024-09-24 21:19:01] |
| John - SC Support - Posts: 36238 |
|
When you change the symbol of the chart, the chart will be fully recalculated. It sounds like your study is not taking this into account and is therefore entering the trade again. Refer to the following: ACSIL Interface Members - Variables and Arrays: sc.IsFullRecalculation Also, if you are changing the symbol of the chart, then your study will not have access to the original data from which the trade was open. Therefore, depending on how your system is setup, it most likely will not be in a position to take you out of your trade, or do anything else that it is supposed to be doing based on the original symbol of the study. So you may not want to be changing the symbol (but again, this depends a lot on how you are trading and what your study does). For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |