Support Board
Date/Time: Sun, 24 Nov 2024 02:37:19 +0000
Post From: Long Entry and Short Exit | Short Entry and Long Exit
| [2024-06-29 15:48:25] |
| Sawtooth - Posts: 4118 |
|
if I isolated each entry into K, L, M, N then Reversal not working correctly.
When using Reversals, columns K, M are the Entry and Exit signals.When using Reversals, you are always in a position, whether long or short. When using Reversals, columns L, N are not used unless the exit condition is not a reversal entry signal. Validating just Long Entry and Short Exit Signal I can find up arrow for Long and buy triggered correctly but no Arrow for short since it was triggered from Column K buying it again instead of exit.
I don't understand this.Is 'Signal Only On Bar Close (K, M) set to No? Arrows only mark close of bar conditions, and columns K, M only show entry arrows. What is in K2 and M2? These are the subgraph name/label cells, and not intended for formulas, unless you want to create a dynamic name. |