Support Board
Date/Time: Sun, 24 Nov 2024 19:24:44 +0000
Post From: Gann Fan
| [2024-05-13 15:13:44] |
| John - SC Support - Posts: 36238 |
|
So you’re saying that I can start a Gann fan with point 1 at the center of a clock and point 2 at 1 o’clock - and another fan with point 1 at the center of a clock and point 2 at 2 o’clock and the 1x1 slopes of both fans are 45 degrees?
Yes, if the distance to the 1 o'clock and 2 o'clock positions are different such that you end up with a consistent rise over run. But if you did the sam distance (same radius of a circle) then the angles would be different. We are not understanding what you are referring to as the "1x1" line. There is only a single number for each line of the Gann Fan. The displayed number for each line is the slope of that line. The line that has a slope of 1.00 is a 45 degree line. Again, it may not (and most probably will not) show as a 45 degree line in the display, but with respect to the price Tick Size and the bar spacing, it is a 45 degree line. Keep in mind the axes you are dealing with are mutable. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |