Support Board

Date/Time: Sun, 08 Sep 2024 00:04:20 +0000

Post From: Ray Drawing

[2024-04-01 13:26:57] Link To Thread - Link To Post [Go To First Post]
John - SC Support - Posts: 34254
The first thing to keep in mind is that whatever Configuration Number has been selected for a drawing will remain selected until it is changed. So if you always want a green solid line and you do not use any other settings for your drawing, then choose a configuration number (typically 1) and change it to what you want and just ensure that the particular configuration number you choose is the selected on in "Tools >> Current Tool Config" when the Ray drawing is selected. Otherwise, if you use multiple settings for your rays, then you need to setup the Configurations for the tool as you want them and then be sure to select the proper one for the drawing you will be doing. You can setup Control Bar buttons to select the drawing tool and a specific configuration number prior to drawing so you can then get what you are wanting. Refer to the following for this: Chart Drawing Tools: Creating Control Bar Buttons which Select Drawing Tool and Drawing Tool Configuration in One Step For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing