Support Board
Date/Time: Mon, 25 Nov 2024 17:38:31 +0000
Post From: How to write alert condition for Volume at Price Greater than X located above the bar open
| [2024-02-27 16:34:46] |
| John - SC Support - Posts: 36253 |
|
You have the right idea. The Alert Condition you would want to use would be similar to the following. =OR(AND(ID1.SG1 > O, ID1.SG1 > C), AND(ID1.SG2 > O, ID1.SG2 > C)) Where ID1 is the ID of the Volume At Price Threshold Alert V2 study which is set to alert when the volume is greater than 2000. Then this checks the first two alerts to see if either one is above both the Open and the Close of the bar. You would have to extend this to however many levels you think you might get in a bar to ensure you cover the full range. Note that the Volume at Price Threshold Alert V2 works from the Low of the bar up, so the first alert (SG1) is always going to be the lowest. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |