Support Board
Date/Time: Mon, 25 Nov 2024 17:40:49 +0000
Post From: Follow Up on Scanning questions
| [2024-02-15 23:28:24] |
| Sierra_Chart Engineering - Posts: 17174 |
|
When this problem is occurring is there a scan active at the time or is it just stopped on one particular symbol: It uses the same exact scan I was using but it had the alerts sound going off noin stop. The attached pic shows CLSK hitting my conditions a bit before noon. It set off an endless amount of alerts for this next few minutes. It did this with all of the stocks hitting my conditions all morning, non stop alert sounds.
If the scan has stopped, on CLSK it could be there would be ongoing alerts if the condition goes from true to false and back to true again. Although alert once per bar should prevent that but we still do not know all the details. Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |