Support Board
Date/Time: Wed, 27 Nov 2024 00:43:19 +0000
Post From: How to get Large Volume Trade Indicator to show up in real time rather than at close.
| [2023-10-16 21:02:56] |
| John - SC Support - Posts: 36309 |
|
The bar period does not matter - it should be showing as soon as there is a trade that matches your settings, but 15 seconds is relatively short, so it could appear that they are not showing until the bar closes - but this would just be happenstance. To verify this, set your threshold to a lower value to see the data increment as new trades are added. Also, the Combine Trades does not delay the updating of the chart. The one item you would want to check is your "Chart Update Interval". There are two values for this, a Chart Specific one and a Global One. By default, all new charts are set to use the Global Chart Update Interval, and by default this is set to 500 milliseconds (one half of one second). Start by checking "Chart >> Chart Settings >> Display >> Chart Update Interval". If this is set to 0, then that means to use the Global Chart Update Interval. The Global Chart Update Interval is set at "Global Settings >> General Settings >> General >> Chart Update Interval". Make sure this is set to a reasonable value (such as 500). Refer to the following: General Settings Window: Chart Update Interval (Global Settings >> General Settings >> General >> Update Intervals) For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |