Support Board
Date/Time: Fri, 29 Nov 2024 14:32:51 +0000
Post From: Cannot get Live “Spreadsheet System for Trading” trade to occur in Simulation Mode Replay
| [2023-02-06 23:22:45] |
| John - SC Support - Posts: 36350 |
|
We are a bit confused on the timing of all the pieces, but it seems like the following gives the answer as to why you are not seeing the order go through in Simulation Mode: Buy Entry | Signal ignored because 'Signal Only Once Per Bar' is enabled and a signal was already given from formula column for bar. | Cell: K3 | Bar start date-time: 2023-02-02 08:10:00 | 2023-02-02 08:10:03.255
This is stating that you have the option for Signal Only Once Per Bar enabled, and it sounds like you may have a situation where the state of the cell was "True" when the bar started, then changed to "False" and then "True" again, but this last "True" did not create an entry due to the fact that it thought it had already done so. We do not know for sure that the above is the situation, it just looks like there is something along those lines occurring. You would really need to take a look at the state of your conditions as you go through. And keep in mind that for the order to be sent, the condition must go from False to True For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |