Support Board

• Support Board |
• Search Board |
• Control Panel |
• View My Posts / Threads |
• Direct Messages

Date/Time: Tue, 26 Nov 2024 11:49:57 +0000

Post From: ATS - Not exiting trades after crossing through moving average

[2014-04-29 00:05:50] Link To Thread - Link To Post [Go To First Post]
vegasfoster - Posts: 444
In K3, =AND(E3>AA3, E4<AA4) In M3, =AND(E3<AA3, E4>AA4) See pic for the chart settings I am using for crossover signal reversal on bar close with following formulas. In general 1) when you look at the entry arrows on the chart are they in the correct place? If not, then you know your formulas have an error. 2) are the signals occurring on the same or different bars than the arrows? If set for entry on bar close you will typically see them on the open of the next bar, consider there could be a small gap. 3) If entries are not occurring on same or next bar from the arrow, do the 5-minute bars not have any volume? Someone correct me, but I believe if no trades occurred then nothing will happen in replay.
0x Thank you
CrossoverReversal.png / V - Attached On 2014-04-28 23:58:45 UTC - Size: 122.98 KB - 361 views