Support Board
Date/Time: Mon, 10 Mar 2025 16:36:17 +0000
Post From: Referencing drawings in formulas
| [2022-03-30 12:31:02] |
| |
|
Yes what you want is fully supported. These two types of references are supported: Reference by Anchor: This uses the values at an anchor point for the drawing in the alert. The format is UDID[x].Ay, where x is the drawing identifier and y is the anchor number. Reference by Bar Value: This uses the value of the drawing at a bar location in the alert. The format is UDID[x][z], where x is the drawing identifier and z is the bar offset. Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service: Sierra Chart Teton Futures Order Routing |