Support Board
Date/Time: Sat, 01 Mar 2025 10:04:04 +0000
Post From: Calculator/Crosshair Integration
| [2021-09-19 15:51:54] |
| John - SC Support - Posts: 38292 |
|
Yes, this is still supported. If you want the measurement to disappear, then it is just a matter of not finishing the drawing. In other words, you would do the following: - Select Chart Calculator from the tools dropdown. - Click to select the first position. - Drag the cursor to the second position to get your reading. - Right-click to end the drawing Refer to the information above for how to have the Crosshairs on during drawing, if that is also something you were looking for. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |