Support Board
Date/Time: Wed, 26 Feb 2025 22:45:44 +0000
Post From: scale multiple studies in same region & show zero values
| [2021-06-01 17:42:54] |
| lovelivelaught - Posts: 57 |
|
Hello I am not sure if this thread is the one that I should refer to? If yes then I could not figure out where I have to go to change sc.Subgraph[0].DrawZeros = 1; I have a chart with 4 studies in the same region. And I would like to change the scale of one of the studies to 'sync' the scaling? I use three TRIX studies with different periods in one region and I would like to add a MACD Hull study (that I found in custom study section). All 3 TRIXs that I have set as Automatic scaling and all of them have same mid line, which is 0 but when I add MACD Hull and set it to Automatic then TRIX studies is not visible as MACD Hull scale values goes from 0 to lets say +- 20 but TRIX scale values goes from 0 to lets say +- 0.020. When I change MACD Hull to Independent scaling then its midline not always sync with all other studies. Is there is any way that I can change scale values of MACD Hull so it can have same mid line with TRIX scale values. Thank you in advance for your help. |