Support Board
Date/Time: Mon, 25 Nov 2024 09:20:19 +0000
Post From: Signal lines disappear when in auto-trade mode
| [2014-01-23 05:17:59] |
| |
|
Switching in and out of Trade Simulation Mode will cause studies on the charts to be calculated because there is a change with the working orders that may be loaded in the chart and also the trade position data, but it should not cause a full recalculation. We have fixed that. The reason this was previously causing a full recalculation is because it would cause a change of the Trade Account for the chart and a full recalculation is necessary as part of the process of rebuilding the internal trade lists. However, switching Trade Accounts between a simulation and non-simulation account, does not require a rebuild of the trade lists because there are already separate trade lists for Simulated and non-simulated order fills that already exist in the chart. All of this discussion in this post, is not related to your problem. It was merely a small optimization we have made after doing some tests. Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service: Sierra Chart Teton Futures Order Routing Date Time Of Last Edit: 2014-02-09 04:57:29
|