Support Board
Date/Time: Sat, 01 Feb 2025 15:49:46 +0000
Post From: Adding to position / scaling out while existing OCO in place
| [2019-07-16 16:47:19] |
| |
|
What you are describing is exactly what Scale In does for you. The way to confirm what you are seeing is simply to look at the order lines on the chart and verify that the quantities are correct for what you are trying to do. You can always test this out in Simulation mode first to see how it works. Refer to the following for the Scale In documentation: Attached Orders: Scaling In Start at the following for information on adjusting what is displayed in the Working Order lines: https://www.sierrachart.com/index.php?page=doc/GlobalTradeSettings.html#ChartTradeSettings_DisplayDetailedOrderInformation And refer to the following regarding Simulation Mode: Trade Simulation Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service: Sierra Chart Teton Futures Order Routing Date Time Of Last Edit: 2019-07-16 17:23:50
|