Support Board
Date/Time: Fri, 31 Jan 2025 15:59:43 +0000
Post From: Auto Trade Spreadsheet - Signal Only Once Per Bar
| [2019-05-09 21:31:00] |
| User37462 - Posts: 31 |
|
Thank you for your response. I think i can use cell J52 instead of Signals only once par bar. But for a strange reason if I add the condition J52=0 (Daily total trades=0) to the spreadsheet it trigger trade at 8:30 - but there are not met True entry conditions. 8:30 is Chart start time and session start time.(New bar at session start is On) This is during replay (Accurate Trading system backtest mode) This happens if previous day was a trade and the replay starts before 8:30. If I do not use J52=0 trade doesnt start - that is correct. (or it is OK if replay starts after 8:30) |