Support Board
Date/Time: Sun, 19 Jan 2025 15:03:43 +0000
Post From: Ray Tool: Extend Distance
| [2018-03-30 15:07:40] |
| PMcG - Posts: 5 |
|
Hi John, OK I will test this next week and report back. I will say however that I have never had issues with rays moving when anchor points are snapped to candles. I can see other users have had success doing this also - see here Trend LInes moving even with 'no lock fill space' Now that anchor end points change when the 'cut drawing here' option is used I suspect this will re-introduce lines move around again. I do not know why anchoring end points to already printed candles/prices holds the rays in place but it certainly does so. Perhaps it's because: 1) The end anchor point has an exact tick value VS a non tick increment value (See 'Anchors_cut' Point B which is 2630.40 instead of .50 etc) or 2) The end anchor point has a defined chart time/value that already exists Vs the new end anchor point date/time value that is assigned to it in open/future chart space or 3) Both/none of the above. Anyways, I will see how things work out next week when the market is open again. Date Time Of Last Edit: 2018-03-30 16:50:40
|