Support Board
Date/Time: Thu, 16 Jan 2025 12:08:58 +0000
Post From: need Renko bar with wicks!!
| [2017-10-22 03:47:44] |
| |
|
One of the main characteristics of those bricks was that the data "underlying" (as given in the Tool Values windows)concerning the O-H-L-C values, always matched the printed graphic, and thus "UP" bricks had Close > Open and "Down" bricks had Close < Open.
This was never ever been the case and this has been so thoroughly documented here for years:Renko Bar Charts: Renko Open, High, Low, Close Values Unless you have the Graph Draw Type on the Renko bar chart set to " Candlestick"? I'm seeing "Up" bricks with Close/Last < Open and "Down" bricks with Close/Last > Open. What is happening?? Make sure Sierra Chart is set for a tick by tick data configuration:Tick by Tick Data Configuration While we cannot say this will never be the case, there could be some incidents of this perhaps for reasons which are not obvious. You need to use the Renko Open and Renko Close Subgraphs as documented. Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service: Sierra Chart Teton Futures Order Routing Date Time Of Last Edit: 2017-10-22 03:49:24
|