Support Board
Date/Time: Mon, 27 Jan 2025 00:37:11 +0000
Post From: Low Level
[2017-09-17 23:48:28] |
Crtfyd - Posts: 281 |
FYI A couple Low Level, not High priority things Ive noticed. 1. When I use a study, and use the "Arrow Up/Dwn", and have the "Tick Offset" set at "Low/High", Ive noticed at a low "Width/Size" it IS at the Low or High ((The tip of the arrow)). BUT as the Width/Size increases, it doesn't stay at the Low or High. I usually "work around" this by adjusting the offset to the size of the arrow, BUT if I want a LARGE arrow at the LOW/HIGH, this won't work because I want the Price (through the Value Label) at the Low of the bar the arrow is at. I can only achieve all three factors (four if I want the extension line at the Low/High) if offset is Zero, Input Data is Low/High, and my arrow is set at a SMALL level. (I cant have a Large [to differentiate from my other arrows] arrow within these parameters. 2. In these same examples Ive noticed if I use the Extension Lines, and have the Value Label of the arrow at "Right Edge", the line covers up my value. I would think it should stop short if the label is "right edge" or disappear behind the value. Don't know if there is a way to "work around" these things, but in any case, low level. Thx |