Support Board
Date/Time: Wed, 15 Jan 2025 18:58:50 +0000
Post From: drawing bug?
| [2017-08-21 17:45:58] |
| User57210 - Posts: 121 |
|
1. Begin with TC1 as configuration. 2. Use regular rectangle draw. Result draws as it should, TC1. 3. Use a custom drawing tool - configuration is set, as it should, to the custom setting. 4. Now attempt to use REGULAR rectangle again - configuration is set to the CUSTOM setting. I don't know how else to say it. The configuration gets STUCK on the most recently used custom drawing tool for future configurations of normal drawing tool use. The setting we need is similar to what you have for what to do after a single drawing use. On any sierra installation I always go in and change it to after single drawing use change to chart values/crosshair. Why have custom drawing tools at all if they are going to change the normal drawing tool config as well? |