Support Board
Date/Time: Sun, 12 Jan 2025 22:12:23 +0000
Post From: Chart Linking: Master Mode Not Working
| [2017-03-11 21:02:06] |
| User80732 - Posts: 26 |
|
Hi There, I've spent quite a bit of time on the support forum, and still to no avail. The "Master Mode" function in advanced settings 2 under chart linking appears to not be working. My problem is I have 3 charts which are all linked "CL1" All three are linked based on chart symbol and scroll position. However in addition JUST #1, and #3 are additionally linked according to bar period. When I change the bar period on #2, they ALL change bar periods accordingly. I'm needing to configure so when I change bar period on #2, #1 & #3 remain unchanged. Here's where I was deriving my understanding: http://www.sierrachart.com/index.php?page=doc/ChartSettings.html#MasterMode Under this section the following example is given: "...For example, given charts #1 and #2, if Chart #1 has Link Symbol enabled and Chart #2 does not have Link Symbol enabled, without Master Mode enabled, when Chart #2 has its symbol changed, then the symbol of Chart #1 will change its symbol to match Chart #2 because it has Link Symbol enabled. When Master Mode is enabled and the symbol of Chart #2 is changed, the symbol of Chart #1 will not change because with Master Mode the Chart Linking options set on the controlling chart instead apply to other charts with the same Link Number. And in this particular example Chart #2 did not have Link Symbol enabled." To test this, I proceeded to duplicate the same scenario above with 2 charts. Both of which were linked. I tried 3 scenarios: 1) selecting Master Mode JUST for chart #1. 2) selecting Master Mode JUST for chart #2 3) selecting Master Mode on BOTH. however in each scenario, when I changed the symbol in chart #2, it also changed it in Chart #1. Please help :) |