Support Board
Date/Time: Thu, 16 Jan 2025 10:00:32 +0000
Retracement and projection tool - problem
View Count: 1000
| [2017-10-19 20:27:04] |
| Vegeta - Posts: 5 |
|
Hello, please tell me why tools like retracement and projection do not start measureing exacly from start or end of candle bar please look what i mean on the picture (link below) on the top You can see that measure start lower than the top of candle and the other choice You can see show that point start measure is lower than bottom of candle this is 5min chart here is image what i mean about https://zapodaj.net/ff040fee8c612.jpg.html Please help me with this ssue |
| Attachment Deleted. |
tt.jpg| [2017-10-20 18:47:31] |
| |
|
Make sure you enable snapping when using these drawing tools so that the endpoints go to the high and low of the chart bars that you want. Refer to: Chart Drawing Tools: Automatic Snapping of Chart Drawing Ends to Open, High, Low or Close Bar Values You can use these commands to snap the existing endpoints of those Chart Drawings to the high and low values: Chart Drawing Tools: Snap to High/Low | Snap Side to High/Low Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service: Sierra Chart Teton Futures Order Routing |
To post a message in this thread, you need to log in with your Sierra Chart account: