Support Board
Date/Time: Sat, 23 Nov 2024 11:07:32 +0000
Post From: Attached Orders Rules
| [2013-06-28 00:09:17] |
| hft168 - Posts: 31 |
|
Hi S.C. Support, I am seeing the similar problem too when running a simulation with spreadsheet using attached order. I configured 2 contracts, then two targets, and it showed the green Target/Stops Match. Then I ran a replay for autotrade. After a few seconds, it started beeping and the quantity reverted from 2 to 1, then the RED Traget/Stops Nomatch appeared, and then the trade service log recorded this: "Trade Order Error: The order quantity for the Parent is 1 and this is less than the total order quantity of 2 for the Attached Orders. Please adjust the order quantities so the parent is greater or equal to the Attached Orders. | 2013-06-27 18:59:23" With the same attached orders setting with 2 stops (OCO Group 1 and 2), I can enter the orders correctly by hand, by errors out when autotrade is doing the work. It should be easy to reproduce with the last few versions. (I was at 988 to 991) Thanks. |