Support Board
Date/Time: Thu, 27 Feb 2025 09:32:00 +0000
Post From: Data display at top of chart
| [2021-06-08 19:21:45] |
| John - SC Support - Posts: 38222 |
|
I am not sure which situation is exactly what is happening, so try the following: 1. In the Sub-Instance, set Trade Simulation Mode to On/Enabled, then try to flatten the position. If that does NOT work, then do the following: 2a. In the main instance, set Trade Simulation Mode to On/Enabled. 2b. Go to the Trade Positions and see if the position is listed there. 2c. If it is, then try to flatten the position. 2d. Go back to the Sub-Instance and ensure that Trade Simulation Mode is Off/Disabled. 2e. Verify that the position is closed out. For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |