Support Board
Date/Time: Sat, 23 Nov 2024 22:20:26 +0000
Post From: Auto Trading Enabled
| [2013-08-19 17:35:14] |
| |
|
If you are not noticing the problem in Simulation mode, then there might be a misunderstanding of the error messages you are seeing. If at the same moment in time you see a message in the Trade >> Trade Service Log that automated trading is not enabled and there is a checkmark by Trade >> Auto Trading Enabled then this is not right. At that time, we could use remote assistance to look into this. But it's really hard for us to believe this condition would exist. Could it be because the same spreadsheet study is applied to several symbols (each on its own sheet/tab, but all in the same spreadsheet)? Suppose I'm trading ES and NQ and then I decide to stop trading NQ but keep trading ES. So I toggle the J28(?) cell on the NQ tab but keep ES unchanged. Could that create a conflict? This is fine and will not cause a problem.
Sierra Chart Support - Engineering Level Your definitive source for support. Other responses are from users. Try to keep your questions brief and to the point. Be aware of support policy: https://www.sierrachart.com/index.php?l=PostingInformation.php#GeneralInformation For the most reliable, advanced, and zero cost futures order routing, *change* to the Teton service: Sierra Chart Teton Futures Order Routing Date Time Of Last Edit: 2013-08-19 17:35:37
|